How do I filter specific IP address in Wireshark?

By Advice

How do I filter specific IP address in Wireshark?

Start by clicking on the plus button to add a new display filter. Run the following operation in the Filter box: ip. addr==[IP address] and hit Enter. Notice that the Packet List Lane now only filters the traffic that goes to (destination) and from (source) the IP address you entered.

How do I filter specific data in Wireshark?

To only display packets containing a particular protocol, type the protocol name in the display filter toolbar of the Wireshark window and press enter to apply the filter. Figure 6.8, “Filtering on the TCP protocol” shows an example of what happens when you type tcp in the display filter toolbar.

How do I filter an IP?

To create an IP address filter:

  1. Follow the instructions to create a new filter for your view.
  2. Leave the Filter Type as Predefined .
  3. From the Select filter type menu, select Exclude .
  4. From the Select source or destination menu, select traffic from the IP addresses.

Which filter is used in Wireshark for capturing a specific type of traffic?

Wireshark capture filters are written in libpcap filter language. Below is a brief overview of the libpcap filter language’s syntax. Complete documentation can be found at the pcap-filter man page.

How do I filter multiple protocols in Wireshark?

Use “or” to combine multiple possible matches as a filter.

How do you change IP address in Wireshark?

replacing a real IP by a false IP

  1. capture source IP, let it = to SourceIP.
  2. capture dest IP, let it = to DestIP.
  3. Let RealIP=192.168. 0.10.
  4. Let FalseIP=192.168. 10.10.
  5. If (SourceIP=RealIP) than let SourceIP=FalseIP.
  6. If (destIP=RealIP) than let SourceIP=FalseIP.

How do I filter a hostname in Wireshark?

Open the pcap in Wireshark and filter on nbns. This should reveal the NBNS traffic. Select the first frame, and you can quickly correlate the IP address with a MAC address and hostname as shown in Figure 5. The frame details section also shows the hostname assigned to an IP address as shown in Figure 6.

How do I filter RTP packets in Wireshark?

Resolution:

  1. On the Wireshark packet list, right mouse click on one of UDP packet.
  2. Select Decode As menu.
  3. On the Decode As window, select Transport menu on the top.
  4. Select Both on the middle of UDP port(s) as section.
  5. On the right protocol list, select RTP in order to the selected session to be decoded as RTP.